Week/Date |
Content |
Week1
|
Day1
|
Hardware and software implementation of start/stop logic for a squirrel cage induction motor
|
Day2
|
Hardware and software to implementation of an On Delay Timer, Off Delay Timer and retentive timer
|
Day3
|
Hardware and software to implementation of a direct on line starter (DOL starter) for a three phase squirrel cage or three phase slip ring induction motor.
|
Day4
|
Hardware and software to implement a traffic lights control system at the junction of two roads meeting perpendicularly.
|
Day5
|
Hardware and software to implement a traffic lights control system at the junction of two roads meeting perpendicularly
|
Day6
|
Hardware and software to implement a stair case light control
|
Week2
|
Day1
|
Hardware and software to implement a switching system where same push button causes the motor to start when pressed once and causes it to stop when pressed again.
|
Day2
|
Hardware and software to implement a motor controller which should start both main motor and its lubrication pump motor simultaneously but allows the lubrication pump motor to run for 30seconds more after the main motor is switched off.
|
Day3
|
Hardware and software to implement a motor controller for a three phase squirrel cage or three phase slip ring induction motor to run forward or reverse as chosen by the operator by pressing the appropriate button.
|
Day4
|
Hardware and software to implement a system using a software counter in programmable logic controller to keep a day’s production record from a particular machine
|
Day5
|
Hardware and software to implement a system using a software up down counter in programmable logic controller to keep a count of number of items in a storehouse
|
Day6
|
Hardware and software to implement a system using programmable logic controller display a 24 hour clock with software counters
|
Week3
|
Day1
|
Hardware and software to implement a delay on timer using software timers in a programmable logic controllers
|
Day2
|
Hardware and software to implement a delay off timer using
|
Day3
|
Software timers in a programmable logic controllers
|
Day4
|
Hardware and software to implement sequential starting of three induction motors one after another with a fixed time delay after the previous motor started using software timers in programmable logic controllers.
|
Day5
|
Hardware and software to implement a water level controller with pump motorcontrol using four switches.
|
Day6
|
Hardware and software to implement a stirrer to mix thoroughly two chemicals one of which is a liquid and the other a powder using counters and software timers in a programmable logic controller.
|